Choosing the Edit » Copy command from the main menus.OutJobs can also hold validation-type checks, such as ERC and DRC reports - useful for a final 'thumbs up' check just before generating the outputs, such reports can then be held as a record that the design was ready for release. For example all outputs required to fabricate the bare board go in one OutJob, all outputs required to assemble the board go into a second OutJob, and so on. The best approach is to use one OutJob to configure all outputs required for each specific type of output being generated from the project. OutJobs are very flexible - they can include as many or as few outputs as required, and any number of OutJobs can be included in an Altium Designer project. Each output is configured with its own settings and its own output format, for example output to a file, or to a printer. ![]() An OutJob (as it is commonly known) is simply a pre-configured set of outputs. This command is used to copy the selected output(s) from the current Output Job Configuration file, to the OutputJob Editor's clipboard. You can only cut and paste between, or within, OutputJob documents.Īpplied Parameters: Action=Copy|ObjectKind=OutputSingle Summary Also, the internal OutputJob clipboard is entirely independent of the internal clipboards used by any other editors in the software. Instead, a separate internal clipboard is maintained for this document type.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |